Home l Hot Products l Machining l Contact Us
Mitsubishi >> Pistons
 
Custom Pistons
Arias Pistons
CP Pistons CP Pistons
Flatlander Racing Flatlander Hypereutectic Pistons
Performance
Flatlander Racing Flatlander Hypereutectic Pistons
Stock Replacement
JE Pistons JE Pistons
MAHLE Pistons
Manley Platinum Pistons
ROSS Racing Pistons ROSS Pistons
ROS Custom Pistons ROSS Custom Pistons
SRP Pistons SRP Professional Series Pistons
Supertech Pistons
TopLine OEM Pistons
Wiseco Pistons Wiseco Performance Pistons
Wiseco Pistons Wiseco 1400HD Extreme Duty Pistons
Wiseco Performance Pistons
Mitsubishi Int'l Marketplace (non-USA)
WOSSNER Rods Wossner Performance Pistons

Custom Pistons: We can make you a forged Piston for any stroke, bore or compression ratio. These can be used for street/strip injected blowers or turbo charged. Call us at (603) 378-0090.

Note on Rods: Based on our 40 years of racing experience, building motors and our 1000's of hours spent on our dyno's, we have found that the Import stock connecting rods are good up to approximately 200HP. If you expect to exceed these requirements by adding Nitrous or Turbo Charging, we strongly recommend that you upgrade your connecting rods along with any forged pistons.
Wiseco 1400HD Extreme Duty Turbo Forging Piston Kits
Check This Out!
All NEW Wiseco 1400HD Extreme Duty Turbo Forging Pistons (USA & Int'l 4G63 & EVO 8)
Click Here

Helpful Piston Information:
Compressions and Overbores:

For Import motors the rule of thumb is 9.5 with Steel Heads, and 10.5 with Alum. Heads dissipate heat and allow for higher compression. Overboring adds to the Cubic inch (more HP), and increases compression.

The European marketplace has for years run their Imports in the 9.5-11.2 range (although they have slightly higher octane gas available).

So, if you want to make some easy HP, raise that compression and overbore. In most cases it's an easy 15-20% HP gain!

Example #1: VW Golf 1.8L (81mm std. bore) 88-91
At 9.0:1 comp = 90 HP
At 10-1 comp = 105 HP
That's a difference of 15% w/o an increased bore!
Example #2: VW Golf 1.8L (.020 overbore) 88-91
At 9.3:1 comp = 82HP
At 9.5-1 comp = 95HP

Bottom Line:
If you're rebuilding for stock or performance, raise the compression & overbore for an easy 15-25% HP
(depending on size).
 
Note: it's just the opposite with Turbos - you want lower compressions and smaller overbores!
 
 
 
 
 
 
 
 
 
 

Order/Tech Line: (603) 378-0090
Email:
info@importperformanceparts.net

Thank You for visiting Import Performance Parts
*All prices on this site are subject to change without notice. Import Performance Parts™ disclaims responsibility for any printing or typographical errors, and does not guarantee that all information is accurate.


home |  FAQ |  contact us |  can't find a part? |  hot products |  site map